MIL-PRF-15733/49K
REQUIREMENTS:
Dimensions and configuration: See figure 1.
Weight: 8.5 grams, maximum.
*
Case: Metal, silver-plated finish for -0001; metal, tin-plated or electro-tin fused except the minimum lead content
shall be 3 percent (pure tin finish is prohibited) or, tin-lead plated or hot-solder dipped (40 percent to 60 percent tin)
for -0002 through -0008, and -0010. Pure tin is prohibited as specified in MIL-PRF-15733.
Seal: Glass-to-metal.
Terminals: Solderable (see figure 1).
Dielectric: Ceramic.
Operating temperature range: -55C to +125C, except -0005 shall be -55C to +85C.
Rated voltage: See table I.
Rated current: See table I.
Insertion loss (at 25C): In accordance with MIL-PRF-15733 and as specified in table I.
(at -55C and 125C): Insertion loss shall be as specified in table I except a degradation of 4 dB
shall be allowed up to 10 MHz.
Voltage conditioning (applicable to -0001, conformance inspection only): Prior to group A inspection, 100 percent
of each lot of filters shall be subjected to voltage conditioning as follows:
Test temperature: +125C +4C, -0C.
Test voltage: 140 percent of the rated dc voltage.
Points of application of test voltage: Between the case and either terminal.
Duration of exposure to test voltage: 250 hours, minimum.
Measurements at +25C after the test:
Dielectric withstanding voltage: 140 percent of rated dc voltage shall be applied for 1 minute.
Insulation resistance: Shall be not less than 500 megohms.
Insertion loss; Shall meet the initial requirements.
A reject shall be defined as a filter that fails the dielectric withstanding voltage test, insulation resistance
requirements, or insertion loss. If the total rejects from any particular lot exceed 10 percent, the entire lot
shall be rejected.
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business