MIL-STD-1285D
APPENDIX N
FSC 5998 - ELECTRICAL AND ELECTRONIC ASSEMBLIES, BOARDS, CARDS, AND ASSOCIATED HARDWARE PRINTED WIRING BOARDS
N.1 SCOPE
N.1.1 Scope. The following define the requirements that pertain to both commercial and military electronic devices. Where the requirements are not stated, refer to sections 4 and 5 herein. This appendix is a mandatory part of this standard. The information contained herein is intended for compliance.
This appendix establishes the marking requirements that apply to a specific FSC. These requirements are to be applied in addition to the requirements of sections 4 and 5 herein. In the event of conflict between this appendix and section 4 or 5, the appendix shall take precedence.
N.2 APPLICABLE DOCUMENTS
N.2.1 General. The documents listed in this section are specified in sections 3, 4, and 5 of this standard. This does not include documents cited in other sections of this standard or recommended for additional information or as examples. While every effort has been made to ensure the completeness of this list, document user are cautioned that they must meet all specified requirements documents cited in sections 3, 4, and 5 of this standard, whether or not they are listed.
N.2.2 Government documents.
N.2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the issue of these documents are those cited in the solicitation (see 6.2).
DEPARTMENT OF DEFENSE SPECIFICATION
MIL-PRF-31032 - Printed Circuit Board/Printed Wiring Board, General Specification For. (Copies of the these documents are available online at https://assist.daps.dla.mil/quicksearch/ or
www.dodssp.daps.mil or from the Standardization Document Order Desk,), 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
N.2.3 Order of precedence. In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
N.3 GENERAL REQUIREMENTS N.3.1 Part identification marking.
N.3.1.1 Guides and extractors/ejectors marking. Card guides and card extractors/ejectors do not require marking of parts.
47
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business