MIL-STD-1285-SUP-2 Marking of Electrical and Electronic PartsThis standard establishes requirements for the physical marking of electrical and electronic parts. This standard should be implemented by incorporating suitable requirements directly in acquisition documents.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56

MIL-STD-1285D

APPENDIX 0

FSC 5999 - ELECTRICAL AND ELECTR0NIC C0MP0NENTS, MISCELLANE0US DELAY LINES

0.1  SC0PE

0.1.1  Scope.  The following define the requirements that pertain to both commercial and military electronic devices.  Where the requirements are not stated, refer to sections 4 and 5 herein.  This appendix is a mandatory part of this standard.  The information contained herein is intended for compliance.

This appendix establishes the marking requirements that apply to a specific FSC.  These requirements are to be applied in addition to the requirements of sections 4 and 5 herein.  In the event of conflict between this appendix and section 4 or 5, the appendix shall take precedence.

0.2  APPLICABLE D0CUMENTS.  This section is not applicable to this appendix.

0.3  GENERAL REQUIREMENTS

0.3.1  Parts identification marking.

0.3.1.1  Mounting pads, gaskets, and heat sinks marking.  Mounting pads, gaskets, and heat sinks do not require marking of parts.

0.3.1.2  Method I marking.  Unless otherwise specified in the acquisition document, marking of delay lines shall conform to method I.

a.  "JAN" or "J" marking. b.  Military part number.

c.  Index mark identification (next to pin 1, input). d.  Manufacturer's source code or logo.

e.  Date code.

49