electromagnetic interference. Filters furnished to the requirements of this specification contain shunting ceramic discoidal capacitors and series inductors \(FSC 5915\). Capacitors furnished to the requirements of this specification contain shunting ceramic discoidal capacitors \(FSC 5910\). For the purposes of this specification, feed-through capacitor types \(C circuit configuration\) are referred to herein as a filter. Passband power may be alternating current \(ac\) or direct current \(dc\) and the filters used primarily in the reduction of broadband radio frequency interference. This specification provides for two levels of product assurance requirements. Filters covered by this specification are capable of operation over the temperature range of -55 degrees C to +125 degrees C.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13

MIL-PRF-28861D

DEPARTMENT OF DEFENSE STANDARDS

Test Method Standard Electronic and Electrical Component Parts.

Method of Insertion-Loss Measurement.

Established Reliability and High Reliability Qualified Products List (QPL) Systems

for Electrical, Electronic, and Fiber Optics Part Specifications.

Marking of Electrical and Electronic Parts.

(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch or from the

Standardization Document Order Desk, Building 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.)

2.3 Non-Government publications. The following documents form a part of this document to the extent specified

herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract.

AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)

Standard Specification for Free-Cutting Brass Rod, Bar, and Shapes for Use in

Screw Machines

Standard Specification for Brass Plate, Sheet, Strip, and Rolled Bar

Standard Specification for Electrodeposited Coatings of Tin

Standard Test Method for Flash and Fire Points by Cleveland Open Cup Tester.

Standard Test Method for Total Mass Loss and Collected Volatile Condensable

Materials from Outgassing in a Vacuum Environment

(Copies of these documents are available at www.astm.org or from ASTM International, 100 Barr Harbor Drive,

P.O. Box C700, West Conshohocken, PA, 19428-2959.)

TechAmerica

Statistical Process Control Systems. (DoD adopted)

(Copies of this document are available at https://techamerica.org/standards or TechAmerica, 1401 Wilson

Boulevard, Suite 1100, Arlington, VA 22209.)

NATIONAL ELECTRICAL MANUFACTURERS ASSOCIATION (NEMA)

Magnet Wire

(Copies of this document may be ordered online at www.nema.org or from the National Electrical Manufacturers

Association, 1300 North 17 Street, Suite 1752, Rosslyn, VA 22209.)

IPC, ASSOCIATION CONNECTING ELECTRONICS INDUSTRIES

Requirements for Electronic Grade Solder Alloys and Fluxed and Non-Fluxed

Solid Solders for Electronic Soldering Applications.

(Applications for copies should be addressed to IPC, Association Connecting Electronics Industries, 3000

Lakeside Drive, 309S, Bannockburn, IL 60015 or at www.ipc.org.)